Articulated Lobster
Remixed by
Copyright Claim
Articulated Lobster
Remixed by
Boost
14
28
12
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
1.1 h
1 plate
0.12mm layer, 3 walls, 15% infill
Designer
1.8 h
1 plate
Boost
14
28
12
0
62
68
Released
Description
Articulated Lobster optimised for Bambu Lab Printers.
Printed on P1S on the High Temp Build Plate.
Original model by The Printing Printer Who Prints Prints With A 3D Printer.
- 0.20mm Layer Height
- 3 Walls
- 15% Rectilinear Infill
- Prints with NO support
For optimal print results, do NOT scale down
Due to its width, the legs of the lobster are extremely fragile and must be handled with care, especially when removing the print from the print bed. Allow the build plate to cool fully before removal.
The model is intended to be more of a desktop décor rather than a flexible articulated toy.
Comment & Rating (12)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed as well as the original
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Very delicate print!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Legs are very thin and break easy. It looks great though.
0
Reply
disappointed, I printed it twice and both times it fell apart immediately :(
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
as the description says...fragile!!! be careful taking it off the plate. if the articulation was slightly bigger or you print with petg or cf then i think you would be ok.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Strength Issue
1
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
Strength Issue:Parts detach when i take it off the plate
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld