Snakon Egg
Copyright Claim
Snakon Egg
Boost
73
88
10
Print Profile(3)
0.2mm layer, 2 walls, 4% infill
Designer
6.5 h
1 plate
0.12mm layer, 2 walls, 4% infill
Designer
9 h
1 plate
0.16mm layer, 2 walls, 4% infill
Designer
7.4 h
1 plate
Boost
73
88
10
0
249
49
Released
Description
Please consider supporting me with a boost on the new system, would love to have more recourses available to make and share Models!!
The Egg from SnakonTheDragon is now here.
Scale as needed to fit the dragon.
Happy Printing
Comment & Rating (10)
All
Print Profile
0.12mm layer, 2 walls, 4% infill
love it!
1
Reply
Print Profile
0.2mm layer, 2 walls, 4% infill
The designer has replied
1
Reply
thanks for the rating!
SnakonTheDragon and the egg goes well together:-)
0
Reply
Print Profile
0.2mm layer, 2 walls, 4% infill
Good print. Would love indicators to how the top and bottom should line up since it only fits in one orientation.
The designer has replied
1
Reply
the seam should be aligning on the inside when putting the egg together. other then that there is some visible scales that align on the outside. Linda hard to spot. My trick was when I printed in 2 color filament. I would match the colors :-)
regards.
0
Reply
Print Profile
0.2mm layer, 2 walls, 4% infill
thank you, fits my friends dragon perfectly
The designer has replied
1
Reply
thanks for the rating.
happy he could use it for the dragon :-)
0
Reply
Print Profile
0.2mm layer, 2 walls, 4% infill
The designer has replied
1
Reply
thanks for rating. enjoy
0
Reply
Print Profile
0.12mm layer, 2 walls, 4% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld