This is a cuttlebone holder SPECIFICALLY DESIGNED FOR PARAKEETS, PARROTLETS AND COCKATEILS. Anything larger or stronger than a conure would easily be able to break it and then this could become a hazard for your bird.

I would recommend printing straight up like the way it is already using tree supports with a 0 percent support density, and make sure the supports come from the build plate and not on the model. I made the mistake and it made it impossible to remove all the supports. 0 percent density and from build plate only supports will allow for easy removal of the support from the entire model. As well as this, make sure there are no easy to chew parts on the print to limit the hazard.

Also please do not use any paint or glue on it as this is extremely dangerous for the bird. It is meant to be printed in one piece for a reason. Please do not scale up or down

This toy was specifically designed for cages with either a 0.5 or 0.75 inch bar spacing, as the clips are spaced 1.6 inches apart. and are 0.4 inches thick. This can fit most sizes of cuttlebone and has a bar to keep it from falling out.

Please post a make I'd love to see your birds investigating it!