Bambu A1 mini Rotary Spool Holder Adapter/ Tentioned holder Adapter
Copyright Claim
Bambu A1 mini Rotary Spool Holder Adapter/ Tentioned holder Adapter
Boost
74
141
16
GIF
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Boost
74
141
16
5
336
107
Released
Description
Recommend PETG
Where a full/mostly full spool can unwind due to the gantry movement at the start of a print. The filament gets wrapped around the arm and then causes a jam.so you need tension holder prevent it.
The spring loaded tension holders can be bought separately from the ams, so you have a tentioned holder.
Caution:
After printing, please fold it first to see if it is strong.Bad and wet filament will be weak.
Clean the brim and put some greace on the thread.Will make your installation smoother.
NEED BUY AMS lite Rotary Spool Holder (yellow)
https://store.bambulab.com/collections/accessories-for-a1-mini?page=3
Comment & Rating (16)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Easy print. Good mod for the A1 mini. Thanks!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Boosted
great thanks for this part
0
Reply
any way you could design one like this for the side of the P1S? someone has one out there but no where near as good as your. it’s just a solid stem that the ams lite spindle forces onto and doesn’t spin freely
(Edited)0
Reply
nice design, can I please have the step file for the cylinder insert part or diameter of the insert ?
0
Reply
worth mentioning that a bladed screw driver is needed to open up the opening to mate the two models
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Related Models
© 2024 MakerWorld