Lightsaber fridge magnet
Boost
123
179
11
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
2.9 h
2 plates
Boost
123
179
11
0
120
101
Released
Description
Lightsaber fridge magnet.
This is designed to print on 2 different plates, one plate for the hilt using the AMS to print the silzer and black. The second plate for the blade so this can be printed in glow in the dark filament (I used geetech blue whigh has worked out pretty well). Of course if you don't want to go with Glow in the dark just print the blade in a nice bright blue/green/red etc.
The blade is a tight push fit into the hilt and then a 4mm diameter magnet by 4mm deep is a tight fit in the end of the blade, no glue needed.
Comment & Rating (11)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Worked as expected. Definitely a lot of purge for such a small object, but it turned out great.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
printed fine
(Edited)The designer has replied
1
Reply
No one else has reported any such issue... Did you print both plates? Which section was left out? Can you upload a photo?
0
Reply
Replying to @crabstiks
nevermind.. I think it was just user error.
0
Reply
Replying to @crabstiks
i changed the rating to 5
(Edited)1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld