This coupler for the AMS Lite connectors helps you guide the filament and slows down wear on the feed connector of the ams , also has a slot to add small sponge to collect debris instead of blocking the motors of the ams. this solution reduce the wear of the ams and avoid blockage of the extruder. This small part will save you money for new AMS motors and save stress of fixing your clogged printer.

This is to avoid specifically this

And if you check your AMS lite you can already see ( after couple of days of usage) heavy dust in the connector that will reach the extruder and clog it.

How to use it :

• Print all connectors
• attach them to the ams lite feed port ( bottom part)
• add the lid to the filament BEFORE feeding to the AMS
• feed the filament
• add a small sponge to collect the debris
• close the connector pressing the lid ( pressure fit)

To remove/change the sponge in the the coupler :

• REMOVE THE CONNECTOR FROM AMS LITE
• Use a flat screwdriver to open the coupler
• DO NOT OPEN THE COUPLE WHEN CONNECTED TO THE AMS

If any of my work helped you and you wish to support me please follow & Like , or buy any of my 3d models on Cults3D : https://cults3d.com/en/users/OlleAdventures/3d-models

Enjoy!