P1S Purge Bucket
Copyright Claim
P1S Purge Bucket
Boost
15
23
14
Print Profile(1)
0.2mm layer, 2 walls
Designer
1.4 h
1 plate
Boost
15
23
14
2
106
104
Released
Description
This purge bucket was made because I couldn't find one that was just right. It is the perfect height and width for the P1S, while not being too big or too small. It also uses less filament than most of the other purge buckets on here.
Comment & Rating (14)
All
Print Profile
0.2mm layer, 2 walls
came out perfect. it’s a little thin but it doesn’t need to be anything more than what it is. absolutely perfect for now!!
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls
can be easily printed at 166% speed and the model comes out clean, bucket also wastes no filament being thin enough to flex under the weight of your hand.
1
Reply
Print Profile
0.2mm layer, 2 walls
einfach und macht genau was es soll, toll
0
Reply
Print Profile
0.2mm layer, 2 walls
Nice simple bucket. Doubled the width and added magnets.
0
Reply
Print Profile
0.2mm layer, 2 walls
extremely thin walls but does its job and printed in ludicrous no issies
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls
0
Reply
Print Profile
0.2mm layer, 2 walls
0
Reply
Print Profile
0.2mm layer, 2 walls
0
Reply
Print Profile
0.2mm layer, 2 walls
0
Reply
Print Profile
0.2mm layer, 2 walls
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld