No Print Profile yet. Add one to earn points.
This is a dual picatinny rail mount for the Crosman 2240.
The model requires a little bit of sanding to make a snug fit. I used some 400 grit sandpaper wrapped around a rod and slightly sanded the inside of both holes.
I also added four holes for brass M3 inserts. These can be melted in with a soldering iron. And I screwed in four grub screws.
It may not be necessary when you already have a very tight fit.
The model is printed in PLA/PHA. No support material is needed.
Model must be printed straight up.
*Edit: Made a slight change to the model. Chamfered the edges and added an insert for a name plate. See picture. Added a dummy name plate as a reference. Reprinted in Woodfill and stained it.
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
20%