/!\ if you use the AMS ready File, you need to swap Black with White after it finish at layer 3.
5 colour filament painting model
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.20mm.
Filaments Used:
- PLA Bambu PLA Matte Charcoal Black
- PLA Polyterra PLA matte Earth Brown
- PLA Polyterra PLA matte Lava Red
- PLA Polyterra PLA matte Earth Brown
- PLA Bambu PLA Basic Orange
- PLA Bambu PLA Matte Ivory White
Swap instructions :
- Start with Black
- At layer #3 swap to Earth Brown
- At layer #11 swap to Lava Red
- At layer #12 swap to Earth Brown
- At layer #13 swap to Orange
- At layer #16 swap to White for the rest
**If Scaling the model make sure not to adjust the Z-Height of the model**