Baby Yoda Light Box by Three Dimensions

Three Dimensions

Household>Decor

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

4.9 h

2 plates

4.3(22)

Boost

163

203

171

Released

Description

Baby Yoda Light STL File- Designed for Bambu lab with 1 AMS unit.

This is a 3D printable file of Baby Yoda, the beloved character from the Star Wars franchise. The file includes all the parts you need to print your own Baby Yoda lamp - Both A front plate and a back plate. The backplate has a channel built in to run your LED light strip in. Link
Once the Light is installed you will just snap the 2 pieces together.

Once you have printed the lamp, you can insert an LED strip into the channel. The light is bright and will make your Yoda lamp look great.

This is a fun and easy project for anyone with a 3D printer. The finished lamp is a great way to add a touch of Star Wars to your home or office.

Comment & Rating (31)

@deebow1985

I've printed over 40 lights and never had this issue

The designer has replied

@user_2560288332

I’ve printed this model 20 times and never seen that before. weird.

@Maxerious

can confirm this doesn't print right has pin wholes/separation i first printed it at 0.08 and it had mostly pin wholes they were small but they were there then i printed it in 0.2 as the bambu sliced file and it was 5x worse sadly wasted 200+ grams of filament should of read the comments first my fault you win some and loose some i even tried tweaking line width to no avail

@Bflip87

Replying to @Maxerious :

I agree - I should have read the comments first. Has a ton of potential, but the full separation in some areas is definitely an issue along with the pin point holes in different areas. Just some small tweaking and it would be great. Until it's fixed, I won't bother adding lights.

@orcutt.alex

GREAT looking file! unfortunately as others have pointed out there are some defects with the file and total separation. circled in red the spots where doesn’t line up and can see the separation at the top.

@mjharrop

yes, three attempts same issues

@mkukie78

Print Profile

0.2mm layer, 2 walls, 15% infill

Super cute, but it separates between the colors and around the sides. I’m not sure how to fix it.

@lowkey1980s

Print Profile

0.2mm layer, 2 walls, 15% infill

came out great, I upped the infill to 20% makes the front a little bit firmer and still lets light theough

@lckaley

Print Profile

0.2mm layer, 2 walls, 15% infill

Looks great when the light is off. There are some small pinhole size spots you can see when it's turned on where the different sections need to be knitted together better