Desiccant Container - Shelf/Cupboard Desiccant Container
Copyright Claim
Desiccant Container - Shelf/Cupboard Desiccant Container
Boost
12
29
15
Print Profile(1)
Ideal - 0.2mm layer, 3 walls, 15% infill
Designer
2.1 h
1 plate
Boost
12
29
15
0
97
67
Released
Description
Desiccant container for fitting on shelves, in drawers, or in cupboards to take moisture out of the air where you're storing your filament.
Comment & Rating (15)
All
Print Profile
Ideal - 0.2mm layer, 3 walls, 15% infill
Lids aren't threaded. tape them or you'll pull out the vacuum each time you'll knock it over
(Edited)0
Reply
Print Profile
Ideal - 0.2mm layer, 3 walls, 15% infill
printed well
0
Reply
Printed well. However, be aware that the lids aren't screwed on or even a particularly tight press fit, so these containers will open and spill beads everywhere if they are knocked over. For that reason, they won't work for my application.
0
Reply
Great print!
0
Reply
Print Profile
Ideal - 0.2mm layer, 3 walls, 15% infill
printed very well
0
Reply
Print Profile
Ideal - 0.2mm layer, 3 walls, 15% infill
It just work
0
Reply
Print Profile
Ideal - 0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
Ideal - 0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
Ideal - 0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
Ideal - 0.2mm layer, 3 walls, 15% infill
0
Reply
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld