Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.1 h
1 plate
Boost
15
27
5
0
40
13
Released
Description
Cat pen holder,my print profile has been tested by me, use it, otherwise put your own settings
Comment & Rating (5)
All
How did you ever print this point?
There is no support and was air-printed.
The designer has replied
0
Reply
Here my result.
0
Reply
I'm sorry, I probably didn't activate the supports in the file but they go there
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed with petg and still turned out very good. kid loves it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld