The pockets inside these models accept Ø6x4mm and Ø12x2mm magnets for the back and bottom positions respectively. It is best to keep the polarity of the magnets consistent between individual prints. In the double magnet version, the 6mm magnet should be inserted with a polarity such that it is slightly attracted towards the 12mm one.

3MF files include tested presets. Generally, use no larger than 0.4n and 0.2l. Some improvement in quality can be achieved with 0.15l. All models can be printed with 0% infill and 2 perimeters. Make sure to not overheat the magnets!

The use of Prusament Orange is mandatory :D.

Local (CZ/SK) magnet sources: Ø6x4mm | Ø12x2mm.