I know there are a lot of nice bag clips here already, but I wasn't entirely happy with any of them, so I added another design. There are 6 sizes for clamping lengths of 55 mm, 65 mm, 75 mm, 90 mm, 120 mm and 150 mm.
My design goals were:
How to use:
As a rule, it is enough to bend the clip on the closure by a maximum of 1 cm in order to slide a bag between them or to remove a bag. It is not intended to bend the clip to larger angles. Bending too hard can cause the clip to break.
To open a locked clip, please use one of the two methods shown here:
Print settings:
A flexible material must be used, such as PETG. I haven't even tried printing clips with PLA since I don't think they will work for long (PLA permanently deforms under tension).
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.