Poop Chute for Paving stone / Cobblestone / Flagstone users with Tray and hidden Handle

Easy acess to the Poop with a pull out tray (if you got low space behind and besides the printer)

stays in place with 3 round Magnets (attached to the printer) d=6mm ; thickness 4mm (3mm will also work when not pushed all the way in)

tray can be hold closed with 4 magnets (Attention at the polarity!) …just optional

hidden handle with Bambu Logo for pull out the tray : flat with front when closed ; for opening push the top part in and then pull at the lower part…very simple and easy…fully printed

optional Lid for "clean design"

This Version is only for Users who using a Paving stone/cobblestone / flagstone 400x400x40mm and 5-10mm rubber mat.

It gives additional Space for the Poop…but of course it takes a bit longer to print. ;)

Find the Original design (without using a flagstone here: https://makerworld.com/en/models/76241#profileId-80830

Improvements to the Original Post:

-more Space for Poop

- deleted the 2 magnets on the side because the printer isn't magnetic there (of course ;) )

- give Space for the flagstone and rubber mat at the sliding area

- made the back of the slide a bit higher (where the poop arrives) to get a bigger range for the heigth of the rubber mat → rubber mat + Stone = 45-65mm

ATTENTION: the print profile uses the PETG/PLA trick so get a super smooth interface between the Tray and the supports!

At All it is still a bit over engineered … but…does it really matter?! ;)

Just let me know in comments when you have suggestions for improvement.