The tiny stylus tips and tip removed that came with the Asus Pen 2 were going to get lost so I made a case for them. It also holds the USB-C charge cable.

There are 4 peices to help make it easier to print. Two tube sections make up the main body and there is a cap for each end. One cap acts as a USB-C cradle for taking it in and out of the tube and the other cap holds the tips and remover tool. There is knurling on the surfaces that need to be screwed together to give a better grip! The whole assembly should fit in a backpack pen holder loop.

A note on printing. The tolerances are not exactly loose, but the X1C was able to handle it no problem! I highly recommend using my BambuStudio file to print it as I optimized some of the supports and brim for the tall tubes. I used Bambulab Dark Blue Matte PLA for the knurled section of the tube and the end caps. The smooth tube section is Bambulab Lava Grey PLA-CF.

Assembly: The two halves of the tube must be glued together. The seem is hidden due to it being right at the edge of the knurling. I used CA glue and have already dropped it and it survived.