Gringotts Piggy Bank with Dragon Lid
Remixed by
Copyright Claim
Gringotts Piggy Bank with Dragon Lid
Remixed by
Boost
32
43
4
Print Profile(2)
0.2mm layer, 3 walls, 20% infill
Designer
13.4 h
3 plates
0.2mm layer, 3 walls, 20% infill
19.6 h
3 plates
Boost
32
43
4
0
50
40
Released
Description
This is a remix of two models. I wanted the Gringotts bank as a removable top piggy bank and a dragon on top. There is a normal lid included as well. The dragon can print completely support free and is colored in the 3mf. The bank can print mostly support free if you slow down overhangs and bridges. I used tree supports at a 4 degree angle to only have the front overhangs supported. It can print completely support free if you clean up the over hangs in the front.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 3 walls, 20% infill
the split to print the model is nicely done but has a little space.
for the coin bank option its not logical that the top stays lose on the model if you glue it you have no way of getting the money out without breaking it.
Overal design is nice would love to see a model where there is a access hole in the bottom/back so you can glue the top on.
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Worked pretty well for me
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld