Lego Duplo Letters Brick Remixed by TheMiguelBi

Remixed by

TheMiguelBi

Toys & Games>Puzzles

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

Capital Letters A-N_0.2mm layer, 2 walls, 15% infill

Designer

3.3 h

1 plate

4.8(4)

Capital Letters O-Z_0.2mm layer, 2 walls, 15% infill

Designer

3 h

1 plate

4.0(1)

Boost

Released

Description

Lego Duplo in Letters version (Multicoloured)
(Capital Letters Edition)

If you are looking for lowercase letters you can find them here: https://makerworld.com/it/models/95563
If you are looking for numbers you can find them here: https://makerworld.com/it/models/95442

Comment & Rating (8)

@dashmik

Print Profile

Capital Letters A-N_0.2mm layer, 2 walls, 15% infill

Thanks a lot, works well

The designer has replied

@TheMiguelBi

Wow! what a beautiful mix of colors! Thanks for sharing your creation!

@Squmanu

Print Profile

Capital Letters A-N_0.2mm layer, 2 walls, 15% infill

looking good, but same here the design is a bit to loose

The designer has replied

@TheMiguelBi

Thanks for the rating. I am sorry about that. Maybe my tests were good because they were placed on plates that were also 3D printed, so both prints had a margin of error... I don't know. Maybe print them with a slight scaling.

(Edited)

@PrintableParent

Print Profile

Capital Letters A-N_0.2mm layer, 2 walls, 15% infill

These were good and the print was fast even with the full alphabet and a few extra letters (and color by height used to make the letters a different color). Just be cautious in removing the brims, if you pull them off too aggressively the bricks won't lock together anymore.

The designer has replied

@TheMiguelBi

Thanks for the rating. Hmm.. I didn't remember including any supporting material! Thanks for specifying that.

@Squmanu

Print Profile

Capital Letters O-Z_0.2mm layer, 2 walls, 15% infill

they are nice! but abit to loose, they won’t stick on the plates - but the kids like them