No Print Profile yet. Add one to earn points.
Design
The base is tilted by 14 degrees, which enables the optimal ejection of ground material. The tilting angle also helps to remove all the grist from the grinder. In addition, clogging of the chute is prevented.
There is a platform at the ejection point of the regrind to also catch the particles flying around. To ensure that the grinded material also lands in the supplied cup, it is magnetically positioned.
If you'd like to buy a finished product visit my newly made store :)
Details
What you'll need
4 pcs. 20x2mm magnets that get glued into the prints. Both the cup and pedestral and the pedestral and the base have cavities. The base has recesses for rubbery feet (25x3mm).
Compatibility
These extensions have been designed and tested with the Eureka Mignon Manule/Facile. Normally, these extensions should fit any Eureka Mignon grinder that has a small, single-colour dial on the right-hand side. So the Specialita, Manuale, Silenzio, Facile, Filtro and Puristico. The grinders with a larger wheel, XL, Perfetto, Libra, will most likely not fit. On Printables are the 3D files to check the fit.
We are working quickly to test and add new models! For further suggestions or questions, don't hesitate to drop us a line!