Audi keychain - RS keychain - quattro keychain - e-tron keychain
Copyright Claim
Audi keychain - RS keychain - quattro keychain - e-tron keychain
Boost
153
197
51
Print Profile(2)
X1/P1/A1 - 0.2mm layer, 2 walls, 30% infill
Designer
16 h
8 plates
A1 mini - 0.2mm layer, 2 walls, 15% infill
Designer
8.7 h
8 plates
Boost
153
197
51
0
394
287
Released
Description
Audi/RS/quattro/e-tron keychain
Visit our collection for other car manufacturer keychains!
https://makerworld.com/it/u/3007967674/collections/170503
____________________________________
Portachiavi Audi/RS/quattro/e-tron
Visita la nostra collezione per altri marchi automobilistici!
Comment & Rating (51)
All
Print Profile
X1/P1/A1 - 0.2mm layer, 2 walls, 30% infill
ve
only 1 layer white. but i dont care.
The designer has replied
1
Reply
Hi, did you change settings? In my print profile it has 3 layers
0
Reply
Replying to @3Dingo
well yes. coz i wanted just 1 of that model. only thing i did was delete all plates exept the one with only one and deleted 1 colour. OHHH i updated the config for this print. Now its 3 layers of white. not before
0
Reply
Print Profile
X1/P1/A1 - 0.2mm layer, 2 walls, 30% infill
perfect, black and white
The designer has replied
1
Reply
Sooo clean!
0
Reply
Print Profile
A1 mini - 0.2mm layer, 2 walls, 15% infill
Nice!
The designer has replied
1
Reply
Thank you! :)
0
Reply
Print Profile
X1/P1/A1 - 0.2mm layer, 2 walls, 30% infill
Bellissimo, mi piace molto
1
Reply
Print Profile
X1/P1/A1 - 0.2mm layer, 2 walls, 30% infill
Amazing results! Thx for sharing.
Printed on: Bambu Lab A1 Mini
1
Reply
Print Profile
X1/P1/A1 - 0.2mm layer, 2 walls, 30% infill
Nice and Clean
1
Reply
Print Profile
X1/P1/A1 - 0.2mm layer, 2 walls, 30% infill
It would be better to make an offset of 0.6 mm of black around the writing because then the interruption on the edge is too noticeable and it must be finished by hand
0
Reply
Print Profile
X1/P1/A1 - 0.2mm layer, 2 walls, 30% infill
The designer has replied
1
Reply
Wonderful texture!!
0
Reply
Print Profile
X1/P1/A1 - 0.2mm layer, 2 walls, 30% infill
(Edited)
1
Reply
Print Profile
X1/P1/A1 - 0.2mm layer, 2 walls, 30% infill
The RS keychain printed excellent and the quality was great! thanks for the upload!
The designer has replied
1
Reply
Thank you for the review!!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld