Sokka Hueforge - Avatar the Last Airbender 143x200.3mf
Sokka Hueforge - Avatar the Last Airbender 143x200.3mf
Boost
12
20
4
Print Profile(1)
0.08mm layer, 2 walls, 100% infill
Designer
3.6 h
1 plate
Boost
12
20
4
0
19
15
Released
Description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA+ Sunlu Black Transmission Distance: 0.2
PLA BambuLab Basic Blue Transmission Distance: 3.6
PLA META Sunlu Teal Transmission Distance: 4.9
PETG JAYO White Transmission Distance: 6.2
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Blue
At layer #14 (1.2mm) swap to Teal
At layer #23 (1.92mm) swap to White for the rest.
Comment & Rating (4)
All
finished print
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
profile was designed to have a primer tower in the same space as the print.
The designer has replied
0
Reply
Just double-checked the profile. Nothing is overlapping. 30+ prints on this, no one else has mentioned this issue. Sorry for your troubles but it's not from the print profile.
(Edited)
1
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld