Hey there,

these are my first print in place models, so please share your experience with a comment or rating!

Today I have for you four different geometic shapes as a planetary gear spinner.

Hope you like them!

When you take the Spinner of the plate, you will need to take of the brim and try to loosen the gears by trying to spin it.

Please be aware that the Spinners will run better eventually with usage over time.

NOTE: Do not push the gears to hard to the sides. They can eventually break out, but they can clicked back in. When normally used, they won't break out.

The example on the picture were printed on my P1P with 3D Consumables PLA.

Glue recommended for Textured PEI Plates.

Created with Onshape