THIS IS A VERSION ONE HERE IS THE LINK TO THE VERSION 2 FINGER SKATEBOARD: https://makerworld.com/en/models/470644#profileId-380131

This is my first design! Ever since I started 3d printing I wanted to learn how to design stuff. This is what I came up with. This is a Print-In-Place finger skateboard or fingerboard. This is similar to a Tech Deck but a lot cheaper. This skateboard is fully customizable.

Print Settings:

Layer Height- 0.2mm

Infill- 15%

Brim- Yes, outer brim only, brim width 10, brim- object gap 0.1

Supports- no!

Printer- Any printer

Grip Tape (Electrical Tape)-

This is not required but will make the skateboard much better and maybe even your favorite fidget toy!

Link to electrical tape- https://a.co/d/5ivgqha

Here is a video I made showing how to clean up your skateboard and add the grip tape (includes specific measurements of sizes of pieces to cut off electrical tape)

Support my shop at https://fin3dprinting.etsy.com
Thankyou!!! Happy printing!!!!