Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA PolyLite Black Transmission Distance: 5.3
PLA PolyTerra Army Blue Transmission Distance: 0.3
PLA PolyLite Polymaker Teal Transmission Distance: 6
PLA PolyLite Temp Purple-Pink-Translucent (Cold) Transmission Distance: 4
PLA PolyLite Magenta Transmission Distance: 2
PLA PolyLite Orange Transmission Distance: 0
PLA PolyTerra Orange light Transmission Distance: 5
PLA Protopasta White Transmission Distance: 3

Swap Instructions:
Start with Black
At layer #5 (0.48mm) swap to Army Blue
At layer #6 (0.56mm) swap to Polymaker Teal
At layer #8 (0.72mm) swap to Temp Purple-Pink-Translucent (Cold)
At layer #9 (0.8mm) swap to Magenta
At layer #13 (1.12mm) swap to Orange
At layer #20 (1.68mm) swap to Orange light
At layer #30 (2.48mm) swap to White for the rest.

Your last slider is set to 2.64mm which is lower than the model height.