Gas Money Ornament / Gift "Box"
Copyright Claim
Gas Money Ornament / Gift "Box"
Boost
53
55
19
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.4 h
3 plates
Boost
53
55
19
1
84
119
Released
Description
Gas Can gift card/ornament. Made to hang as an ornament but has a flat bottom to sit on a table. "Gas Money" labeled on both sides of the can. Makes a wonderful gift for those hard to buy for teenagers.
Supports are not necessary, but are applied with tree supports for the arch of the money holder tube as they are small and waste minimal time.
File is designed to print in half, with included pegs to snap together. The nozzle snaps on also, no glue needed. There are three different sizes of pegs included in pairs of two. From top to bottom they are at 90%, 95%, and 100% on the build plates. I included these as some filaments shrank more than others during test printing.
Comment & Rating (19)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
haven’t printed the nozzles yet for this set, but this print great and made a great gift for all the teens in my life
The designer has replied
0
Reply
Glad you liked them! I printed quite a few myself for the holidays.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very easy print w/ Duramic3D Red PLA+ and Black. Made a great Easter gift!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The large pins were to big, the medium ones fit tight but seemed too long and the two halves wouldn’t squeeze together tight. Used the small ones and super glued two halves together. Have a couple of nephews and nieces we never know what to get for Christmas and usually get gas gift cards. This looks like a more fun way to gift them gas money.
0
Reply
Getting loads of non-manifold edges errors. Tried to fix but it gets stuck trying to fix via "Windows service".
The designer has replied
0
Reply
That is a byproduct of me cutting the model in bambu studio to make it easier to print. It will print fine, if you would like me to post the stl of the can whole I can.
0
Reply
Replying to @lindnjoe
I didn't try to just print it yet. I'm new and so I didn't know what to do so I hit the repair. I'll just try to print and see what happens. Thanks!
0
Reply
Replying to @thewailers2000
I use the uploaded file to print the ones I make with. No problems printing it. :) Welcome to the fam!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
after I made one multiple people wanted me to make more think I've made like 10 of them
The designer has replied
0
Reply
Glad you liked it! :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
make sure you keep up with what is the left side and the right side. lol.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld