Roborock S8 Pro Ultra S-Bag tower by jori.helin

jori.helin

Household>Other House Models

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 15% infill

Designer

5.6 h

1 plate

Boost

Released

Description

For easier use of S-bags on the Roborock S8 Pro Ultra base station. Adapter made previously worked just fine, untill bag got overly full and made a blockage through the adapter plate.

This version replaces original bag holder tower from the base station with one that accepts S-bags directly and no more issues removing the bag when it's full.

This is V1, still in testing.

No permanent modifications required to the base station. Accepts S-bags without modification.

Print all 3 pieces.
Use 2 M4x20 screws and nuts to attach lock to the tower.
Remove old tower from the base station by unscrewing 3 screws.
Install new tower using original screws.
Install S-bag by sliding bottom in and press sides against the tower.
Slide the lock in place.

Coffee?
https://ko-fi.com/jorihelin

(I take no responsibility if you break your base station or any other issues that could arise from using the model. Print and use with your own risk.)

Comment & Rating (2)

@soldius123

Hi, thanks for designing this. Though, i stumbled upon this by chance. Is there any reason you'd pick using this type of bag over the original? Pricing does not seem to be that different. I'm genuinely curious about this, just can't find any obvious answer to it when I googled. Thanks ahead of time :)

The designer has replied

@jori.helin

main reason was availability and because my regular vacuum cleaner also uses the same bags. When i got the Roborock, original bags were not available at all. Thanks for question.

No more