I was just messing around with some generative design utilities and thought it would be cool to make snowflakes for my tree. I tried to incorporate some sacred geometry themes as well. Why not have some decorations on the tree that are almost impossible to manufacture any other way to show off what these machines can do? These have complicated enough geometry they're a little like torture tests so I split these into printing on 2 separate plates so if one fails it doesn't take out the whole plate. Please check on it about 15 minutes into the print as long as the initial support structures print okay you should be fine. They are remarkably strong printed in PLA Plus though! I would recommend slowing the print down a little from what you normally would run, but this profile worked for me.