Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.8 h
1 plate
Boost
22
30
9
0
47
31
Released
Description
Nice keyholder printed with 4 colors.
Mounted with 3x 3.5mm screws to wood or wall.
Comment & Rating (9)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Muss noch aufgehängt werden, aber sieht sehr toll aus!
Habe die Farben auf Schwarz-Weiß angepasst um es Simpel zu halten.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
came out great after scaling. default was way to small. scaled to 160% and works great
0
Reply
The coloring job leaves a lot to be desired, as the black infill under the white is very visible, but otherwise a really cool model. Thanks!
The designer has replied
0
Reply
This can be solved, by toggling setting Flush into infill in slicer. I did like this to save some filament on purging.
1
Reply
Can you add this for a A1 Mini?
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Rated this once, not sure what happened! Solid print, but don't flush to infill. The white part is a little transparent at the original size.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Strength Issue:it’s far too weak and tends to come apart on dismounting it from the plate , sad really
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld