Build Plate QR Code Alignment Tool for Bambu Lab Third-party Build Plates by Roland Deschain

Roland Deschain

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

18 min

1 plate

4.7(31)

Boost

102

303

241

Released

Description

I love these build plate QR codes created by elumpse but I struggled to get them placed correctly. Using the provided alignment tool I continued to receive the build plate localization marker error on some of my plates.

This alignment tool was designed for 5mm² QR codes with a 1mm border. It should snap on to your build plate and be pushed up against the bottom. Center the QR code between the arms of the alignment tool with the top edge resting against the center peg (see picture).

I used a stock dual-sided textured plate, with the notch on the right side, to come up with the measurements.

Warning: If you print a third party profile you may not be getting the latest version or the highest quality print.

If you like this project, please don't forget to ❤ Like and ★ Rate!

Comment & Rating (38)

@Kingmob

Exactly what I was looking for, thanks. I applied it with glue and added a small layer of epoxy on top, hopefully that'll make it waterproof.

@Carlos_Gwn

Why are there 2 QR codes for textured?

@Evilbucket

Print Profile

0.2mm layer, 2 walls, 15% infill

worked out great for a newly purchased plate

@Bostra

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect.

(Edited)

@FRIARTUCK11

The print profile is no longer public

Worked great. It was a little tight on my bed width since it’s a little bigger than bambu’s but it was good enough for the job.

@Thibodoit

The print profile is no longer public

printed in PETG the print seemed to go a bit fast and left some unclean edges, but it fit perfectly

(Edited)

@LJNZ

Print Profile

0.2mm layer, 2 walls, 15% infill

worked perfectly! thank you

@SuperTech

Print Profile

0.2mm layer, 2 walls, 15% infill

it gets the task done

@JohnBody

Print Profile

0.2mm layer, 2 walls, 15% infill

Did exactly what I needed it to do. quick and easy

@rock056

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed with no issues, perfect fit

@TheEngineer

Print Profile

0.2mm layer, 2 walls, 15% infill

While I like the design of the tool, when I compare the alignment to a Bambu textured PEI build plate there is measurable misalignment. Same can be said when comparing to the as delivered cold/engineering plate. In short I followed the link in the description, printing that tool which while less convenient matched the genuine Bambu plate QR code locations.