Summary

Have fun with Stormtrooper Astronaut
The design was remix from Apollo Astronaut and Stormtrooper Helment, the result looks funny and cute.

No addition support need, easy to print.

The design can print without support and raft set.
Layer high from 0.15mm~0.3mm is fine.
Infill better to use over 10%.

Check out more cool design on
http://www.ddf3d.com/

Hope you will like it ;)

Comment & Rating (12)

@emtg42

nice print overall. does anyone have any suggestions for the back of the storm troopers head? I’ve printed it a couple different times, and various sizes and each and every time the little supports that it comes with breaks off a hole in the back of his head. I can’t seem to figure out how to get it off without it. I’ve even tried carefully and used a razor knife. I think the file would be better without the added supports and just using manual tree supports.

@AU3D

I used a side cutter but I agree, the support are not optimal.

@bingusbangus

Print Profile

~10cm height | Brim | fixed Position | 0.16mm layer, 2 walls, 20% infill

very gud

@kylejayceo

Print Profile

~10cm height | Brim | fixed Position | 0.16mm layer, 2 walls, 20% infill

prints super nice but like others said the back of the head comes off with the supports :/ but I melted some to the back and looks better then the hole lol