Mandalorian Helmet v2 - SUPPORTLESS
Remixed by
Copyright Claim
Mandalorian Helmet v2 - SUPPORTLESS
Remixed by
Boost
167
346
114
Print Profile(11)
HEAD DIMENSION TEST
Designer
23 min
1 plate
HELMET v2
Designer
17 h
1 plate
VISOR
Designer
15 min
1 plate
ACCESSORIES v2
Designer
4.5 h
1 plate
Click to see more
Boost
167
346
114
10
784
615
Released
Description
Before starting to print the helmet, check if your head fits well printing the dimension test
Helmet visor: https://www.amazon.it/gp/product/B078YYQVWN/ref=ox_sc_saved_image_10?smid=A3R2BN8GAL312Z&psc=1
If you don't want to spend money for this item, you can print your own visor (in the profiles list), but the result could not be perfect.
If you have some issues printing accessories (bottom ears could fall), you can print them separately. The profiles are available in the list.
11/16/2023 UPDATE: Added a new 1:1 (100%) scale version sectioned into 4 parts to glue. The accessories have also been adapted to size.
Comment & Rating (114)
All
Print Profile
HELMET v2
Thanks for this great Helmet . i love it .
Boba Fett Helmet is the next 😉
The designer has replied
2
Reply
Thank you
0
Reply
link on the face shield. I have been wracking my brain to figure the best results
0
Reply
Has anyone figured out how to cleanly remove the "remove me" section of the visor?
The designer has replied
1
Reply
Use a dremel or a little saw tool for driller. Is very easy to remove
0
Reply
I used my needle nose and finished with my wife nail file. 😈 and then put it back hehehe
0
Reply
I tried to cut/pry take them out with a knife. Got a little ways then cracked through the ears. Don’t do what I did. I’ll have to start over.
I put some modifiers in at the top and bottom of the “remove me” section to make the walls thinner there. its probably the only reason I got anywhere with my knife. I think it would be a good tweak in general.
0
Reply
Print Profile
HEAD DIMENSION TEST
Great file, head dimension test fits.
I was not able to print the helmet without support - big problems at the top.
Second print I put some support at the top and reduced the speed to 50%. Result will be shown if successful.
The designer has replied
0
Reply
I'm so sorry. Probably the material or the cooling are not so good. I was able to print it without problems
0
Reply
Second try - much better result
0
Reply
Print Profile
HELMET v2
Other than the banding every few cm it printed very well. Could be my printer but it's less than a month old. Checking belts and other stuff now.
0
Reply
that's a printer problem. might look into your filament or do some maintenance your machine.
0
Reply
Boosted
Print Profile
HELMET v2
printed nicely.
1
Reply
Print Profile
HELMET v2
ran out of filament halfway through but looks great!
1
Reply
Boosted
nice print file, love that fitting jig.
very smooth print with your print file. Thanks!
0
Reply
Boosted
Print Profile
HELMET v2
Love it! It was 98% good for me, and there was even room left for the sponge.
0
Reply
Print Profile
HELMET v2
Printed great, would recommend. The test fit did not lead me astray either.
(Edited)
0
Reply
Print Profile
HELMET v2
The top section sagged a bit, not perfect. And the visor section was very difficult to remove.
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld