Hex key holder
Copyright Claim
Hex key holder
Boost
6
16
10
Print Profile(1)
PLA+, 0.2mm layer height, 0.4mm nozzle, auto brim (no brim)
4.5 h
3 plates
Boost
6
16
10
0
62
38
Released
Description
Sturdy quick print hey key holder/sheath. STL for both SAE (.050 - 3/8) and Metric (1.5 - 10) allen wrenches. I used pla + with 2 raft layers 15% infill. This is a pretty straight forward print. Thanks for checking it out.
Comment & Rating (10)
All
Print Profile
PLA+, 0.2mm layer height, 0.4mm nozzle, auto brim (no brim)
Good print
0
Reply
Print Profile
PLA+, 0.2mm layer height, 0.4mm nozzle, auto brim (no brim)
(Edited)
0
Reply
Did not fit very well for me
1
Reply
Print Profile
PLA+, 0.2mm layer height, 0.4mm nozzle, auto brim (no brim)
Great print works better than the OEM. Thank you.
1
Reply
Printed Both the Stanard and Metric, helped organize my misc. Allen Keys. Thanks for the models!
1
Reply
Why standard is imperial? For me, standard is metric. There is no standard. There are imperial and metric...
0
Reply
Print Profile
PLA+, 0.2mm layer height, 0.4mm nozzle, auto brim (no brim)
Other Issues:Holes were too small to fit allen wrenches. I will review my calibration and retry
1
Reply
Print Profile
PLA+, 0.2mm layer height, 0.4mm nozzle, auto brim (no brim)
Other Issues:Most of the whole were too tight and it did not work for me.
1
Reply
Print Profile
PLA+, 0.2mm layer height, 0.4mm nozzle, auto brim (no brim)
1
Reply
Print Profile
PLA+, 0.2mm layer height, 0.4mm nozzle, auto brim (no brim)
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld