Love by Never Disarm

Never Disarm

Household>Decor

Print Profile(3)

All

P1P

P1S

X1 Carbon

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill (New profile with new Pin)

Designer

6.1 h

1 plate

4.7(56)

Tighter hole on base for better fit

6.2 h

1 plate

4.7(11)

70% mini friendly 0.2mm layer, 2 walls, 15% infill

3.9 h

1 plate

4.4(5)

Boost

338

509

905

433

Released

Description

Happy Valentine Day

Comment & Rating (91)

@xtraspin

Print Profile

0.2mm layer, 2 walls, 15% infill (New profile with new Pin)

Cute model. the stand hole is too large or the mounting peg is too small this allows the model to rock left and right. wish the fit was tighter and the model would stand straight up.

(Edited)

@3damericana

had the same issue but other than that, it was awesome

(Edited)

@F_K3NT_D

Replying to @3damericana :

I added a print profile that corrects this issue

(Edited)

@2ndstoryprinter

I loved this heart from the moment I saw it. I gave it to my wife today !!

The designer has replied

@NeverDisarm

Thanks! and nice print

(Edited)

@F_K3NT_D

I added a profile with a tighter hole on the base to better hold the heart. All I did was added a block in Bambu Studio and resized it so that it sits within the original part and cannot be seen. Carefully apply a little force to push the heart into the base, no glue required.

The designer has replied

@NeverDisarm

I advise you to check your printer settings because there is no gap in the drawing; so if it is too wide for you there is some problem in your settings

@F_K3NT_D

Replying to @NeverDisarm :

I'm not the only one experiencing the issue. The heart fits in the hole but it's way to loose causing it to lean. I tightened the hole with a block in Bambu Studio so that when the heart is put on the base it basically becomes one piece.

@straight606

Print Profile

0.2mm layer, 2 walls, 15% infill (New profile with new Pin)

awesome print!

@user_3071068688

Boosted

Print Profile

Tighter hole on base for better fit

Wife loved it. Turned out awesome with the textured plate.

@Zeusfpv

Print Profile

0.2mm layer, 2 walls, 15% infill (New profile with new Pin)

bellissimo

(Edited)

@Juggernaut

Print Profile

Tighter hole on base for better fit

Schwarz verläuft etwas ins Rote trotz Reinigungsturm. Ein sehr schönes Motiv.

@mattyromani

Print Profile

0.2mm layer, 2 walls, 15% infill (New profile with new Pin)

Perfect

@petrne87

Print Profile

0.2mm layer, 2 walls, 15% infill (New profile with new Pin)

👍

@user_2767049368

Print Profile

0.2mm layer, 2 walls, 15% infill (New profile with new Pin)

Love the design. The mounting table is 1.5 mm too long and must be trimmed. Be very careful not to remove too much material. A Plastic CA with activator used sparingly will create a solid bond with the base. Great work and thanks for sharing.