This is the inner pot for my Simple Pot 2 Spiral - Planter.

It has a waterindicator to see how much water is left. You have to stuff the underpart with styrofoam so that it floats. But be careful because this part is very fragile.

Before planting:

Please make sure that the rod is up to the top line of the cap when the water level is full (water up to the top edge of the inner pot). If this is not the case, then measure approximately the height of the rod from the cap and feel free to contact me! I will send you a new cap.stl with your measurements.

Dimensions:

• inner diameter at the top: 87.2mm
• inner diameter at the middle part: 77.4mm
• inner height: 76.8mm
• height water reservoir: 24mm
• height waterindicator: 14.2mm
• wall thickness: 1.2mm

Settings:

• layer height: 0.2mm
• line width: 0.42mm
• wall loops: 3
• infill: 100%

Note:

As you scale the pot the wall thickness will also change. Feel free to contact me for other Dimensions!

Feel free to upload your makes!