3D Printed Tape Measure Holder adjusted for EU sizes
Remixed by
Boost
13
24
11
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
38 min
1 plate
Boost
13
24
11
0
77
86
Released
Description
📏 3D Printed Tape Measure Holder for typical 15-18 mm Wide, 182 cm Tape 📏
It has been adapted to work with European tape sizes.
Check out this cool 3D printed holder for your soft tape measure! It's perfect for tapes that are 18 mm wide and 150 cm long.
🔸 Just Right for Your Tape: Made specially for 18 mm wide, 150 cm long tapes. It holds your tape just right.
🔸 Strong and Lasts Long: We use tough materials to make sure it can handle lots of use.
🔸 Easy to Put Together: Just use a bit of super glue to stick the pin in the center, and you're all set.
🔸 Handy and Small: It's easy to carry around in your pocket or toolbox.
🔸 Keeps Your Tape Neat: No more tangled tapes! This holder keeps your tape nice and tidy.
Comment & Rating (11)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
nice print!
0
Reply
will not print properly
The designer has replied
0
Reply
what kind of problem did you encounter? i tested and it worked fine.
0
Reply
the center hole in base gets clogged with debris from filament trying to fill hole
0
Reply
Replying to @bowhunter1401
This was on purpose to avoid supports, but I have now updated the design with minimal supports.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed perfect, thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Tolerances weren't great.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
Related Models
© 2024 MakerWorld