Claymore Mine Model
Copyright Claim
Claymore Mine Model
Boost
39
65
18
Print Profile(1)
0.16mm layer, 2 walls, 10% infill
Designer
2.9 h
1 plate
Boost
39
65
18
0
129
96
Released
Description
Claymore-inspired Anti-Personnel Mine Model, inspired by the M18 A1. This unique piece makes for a striking desk decoration. The model is easily 3D printable without requiring supports. Simply glue the top part and legs together for assembly. For optimal stability, it's advisable to glue two legs together first and then attach them to the main model. In case of any issues with leg strength, consider scaling up the legs slightly.
Comment & Rating (18)
All
Print Profile
0.16mm layer, 2 walls, 10% infill
Support Issue:top lip needed supports
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
droopy at top lip but will arm the rumba and she will wear it well.
2
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Printed from mobile so I wasn't able to review print settings beforehand. The print came out decent but the speeds were a little high and caused some overhang issues where the model flares back out near the top. I was able to clean most of it up in post but I think it would be better if slowed down slightly. Otherwise, it is a great model. Thank you for sharing.
1
Reply
I got this attached to my front door, right under the peephole. Heh.
The designer has replied
0
Reply
I hope it will discourage home intruders! Feel free to share some photos
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
😎
(Edited)The designer has replied
0
Reply
😎
(Edited)1
Reply
Great idea!
1
Reply
i love claymores
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld