Zuko Hueforge - Avatar the Last Airbender 143x200
Zuko Hueforge - Avatar the Last Airbender 143x200
Boost
18
29
4
Print Profile(1)
0.08mm layer, 2 walls, 100% infill
Designer
4.1 h
1 plate
Boost
18
29
4
0
21
22
Released
Description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA+ Sunlu Black Transmission Distance: 0.3
PLA BambuLab Basic Red Transmission Distance: 5
PLA BambuLab Basic Orange Transmission Distance: 10
PLA BambuLab Basic Yellow Transmission Distance: 6
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Red
At layer #12 (1.04mm) swap to Orange
At layer #18 (1.52mm) swap to Yellow for the rest.
Comment & Rating (4)
All
Print Profile
0.08mm layer, 2 walls, 100% infill
probably my most favourite one out of the whole set! amazing!
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld