Jet Engine stand with non-slip Remixed by Yedoggie

Remixed by

Yedoggie

Education>Engineering

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

4.1 h

3 plates

5.0(20)

Boost

110

296

202

Released

Description

I modified yohann LEFEUVRE design by adding TPU to the Patins (Pads) so that the Jet engine sitting on there would not slip easily when you are rotating the compressor. THe original design was good but did not hold the jet engine well when fidgeting with it. The whole jet engine would slip and roll on you. By printing a TPU pad and gluing on the Patin, it greatly helps preventing any unwanted movements.

jet

jet engine

jet fan 2

jet engine model components kit

turbine

Comment & Rating (26)

@user_2146661292

Nice detailed engine stand. However it is a little bit too wide to fit the engine nicely. (it now "hits" the screws) Should be nice if the stands are 3 to 5 mm closer to each other. Never the less, happy with the result.

The designer has replied

@Yedoggie

its made to sit as the picture for the file.

@user_2146661292

Replying to @Yedoggie :

Yes, I see it now. How could I think it that way at first. :-) Any how I'm happy with it.

@BiMein

Print Profile

0.2mm layer, 2 walls, 15% infill

gefällt mir sehr gut, vielen Dank für ihre Arbeit

@Thor

Print Profile

0.2mm layer, 2 walls, 15% infill

works great with the Support-PLA

@PrinterDan84

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect alternative Stand- thank you 👍

@BrianMDK

Print Profile

0.2mm layer, 2 walls, 15% infill

Excellent 👍🏻

@Narrenkoenig

Print Profile

0.2mm layer, 2 walls, 15% infill

@iamwhoiam

Print Profile

0.2mm layer, 2 walls, 15% infill

@bastian123f

Would it be possible to change the licence type to "CC"? I have designed a Version with a touch-sensor and ESP + Motor for my own, but i wanted to share this as a remix of your work.

The designer has replied

@Yedoggie

done

@bastian123f

thank you very much

@luckyluc.64

Print Profile

0.2mm layer, 2 walls, 15% infill

Nicely done. The details level is perfect. I did remove the soft pad and stand it back a little. If it was 10~12 mm shorter I could use the pad. I did appreciate the fit of the pins, it came out perfect. Thanks for sharing.