Gaming Coasters
A fun little project I made with Epoxy and left over PETG filament I had.
Size: 95mm x 95mm x 6mm
You can mix and match the shapes as you like, I recommend printing the Coaster Rings with a .2 nozzle if you want to keep as much details as possible for the outer shapes with snug supports.
Use a 100% infill for the desired card/dice shapes, this will prevent them from floating up.
How to make it:
I used 4 inch tape on which I placed the Coaster Ring, this provided sufficient seal to prevent the Epoxy from leaking out.
I recommend adding the Epoxy in 2 steps (without the shapes they can hold about 47ml of Epoxy):
It might take you a few tries to get the desired results, be careful with the Heat Gun, try not to push the Epoxy over the edges of the ring.
You can use wooden toothpicks to help the Epoxy stick to the edges of the ring.
For the Dice, I've printed the Dots separately since I don't have the AMS for multicolor printing, they fit snuggly in the Dice so no need to glue them. (At least they did with my machine)