BS-16 Pistol Grip by Qwerm

A knock off of TangoDown's BG-16 AR pistol grip. This release also includes a STL that allows you to create a textured section on the grip.

This grip is smaller than my BS-17 so if you find this too small I suggest checking out the BS-17.

Orientation: Print it facing up.

Settings Used:

Material: PLA+

Extruder Temp: 210c

Bed Temp: 60c

Layer Height: 0.20mm

Wall Line Count: 4

Infill Percentage: 30%+

Support: No

Fuzzy Skin: Enabled

Fuzzy Skin Outside Only: Enabled

Fuzzy Skin Thickness: 0.1mm / 0.4mm

Fuzzy Skin Density: 10.0mm / 5mm

Read the included PDF guide on how to use multiple fuzzy skin settings. 

This work is licensed under CC BY-NC-SA 4.0. To view a copy of this license, visit http://creativecommons.org/licenses/by-nc-sa/4.0/