Here is a lithophane for The Hobbit - Smaug Destroying Lake Town

It has a 3mm thickness and a 3mm border around it.

My printing dimensions;

• height is 75% of width

Thus, if the width if 120mm, then the height I use would be 90mm.

• I like printing my pictures standing up, I personally think it looks better. I tried printing a image flat....it looked very very bad. I personally will not try it again.

• I suggest using 100% infill to remove as many air gaps as possible, you do not really use much material anyway.

• You should use a brim to print this, I tried a raft but because the image is tall, it was not able to stand up straight and the print failed.

I am the owner of https://www.neocrisis.com