X1C Purge Bin (works with spool holder) by djlester

djlester

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 50% infill

Designer

9 h

1 plate

5.0(7)

Boost

Released

Description

Poop/Purge/Waste Bin for Bambu Labs X1C

2-piece design
Removable
Low Profile
Works With: rear spool holder, AMS, and printer stabilizer/riser/paver stone

Note: 2ea 15mm long screws (from printer unboxing *with AMS) are required to install flange on the back of the printer

Comment & Rating (7)

@user_958157012

Print Profile

0.2mm layer, 2 walls, 50% infill

it’s UGE!

@rycyt

Print Profile

0.2mm layer, 2 walls, 50% infill

Great print, extremely pleased with the result! Best option I’ve seen for anyone with a concrete paver/riser.

@biggusdickus

Print Profile

0.2mm layer, 2 walls, 50% infill

works great! I printed in a bunch of excess filament lying around - just wanted to use up the scraps. I do wish there was a slight slope in the bucket because I’ve had a couple poop chute backup issues with this. Other than that, I love how secure it is and how easy it is to remove!

@joshc328

Print Profile

0.2mm layer, 2 walls, 50% infill

Exactly what I wanted. Big, removable, and does not interfere with the AMS, filament spool or the pavers the printer sits on. No issues printing. I personally used two screws that came with my P1S upgrade kit. (The screws were long enough to reach through the attachment on the back and to the holes. I did need to slightly enlarge the holes, but the holes were not intended for the screws I used)