2.5" Conduit Clamp
Copyright Claim
2.5" Conduit Clamp
Boost
4
5
3
Print Profile(2)
2.5" Conduit Clamp (centered holes)
Designer
50 min
1 plate
2.5" Conduit Clamp (closer holes)
Designer
50 min
1 plate
Boost
4
5
3
1
11
12
Released
Description
Here is a 2.5" Conduit Clamp that I designed in Onshape. there is one version with holes in the center and one with holes closer to the wall.
0.2mm Layer height
2 walls
infill 15% - 100% (depends on your use)
Rafts NO
Supports NO
Orrientation (on its side)
Comment & Rating (3)
All
Print Profile
2.5" Conduit Clamp (centered holes)
Made from PETG and installed outside. So far holding up great.
0
Reply
Good basic model. Printed at 160% for 4" vent pipes.
0
Reply
Print Profile
2.5" Conduit Clamp (closer holes)
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld