Inspired by : https://www.thingiverse.com/thing:5427426

!!! CHECK OUT THE UPDATED VERSION ON MY PROFILE !!!

WZ3605E power supply enclosure with proper ventilation.

Printed using the default 0.2 profile with a 0.4 nozzle.

Set the print to be oriented automatically and print with Tree supports (i don't recommend printing without supports).

Parts needed to assemble the entire unit :

-WZ3605E or similar
-DC Barrel Jack to 2 pin (as it fits directly into the support i made for it)
-2x 4mm banana socket connector
-10x15 on off button
-2x screws m2x4
-19 - 22 AWG copper wire
-Heat shrink tubes

Psu_cover screws into the enclosure on the bottom with two m2x4mm.

Connected everything inside with 22AWG wire (change wire size according to your load expectation).

It is a bit tricky to put everything together but it can be done.