Hello,

With the original orientation of the model on the plate, the model left very little room for the rear-most tree supports. The rear tree support would have a fraction of the surface layer area that a tree support would have normally, and on a bed slinger such as the A1, the rear most tree support would always fall down at about 75% completion because they lacked good bed adheasion. That would cause the printer to print mid-air and create a mess near that back area of the model.

The easy solution is to rotate the model diagonally on the print bed, allowing for alot more room and a full tree support. Worked great!

Complete list of changes made in this remix:

• rotated model diagonally on the bed to allow full surface layer area for good tree support adheasion.
• changed from .24 to .20 layer height throughout
• changed from 15% gyroid to 15% rectilinear (reduces print time)

Thank you,

BennyBoots