Munitions Boxen zum anpassen
Infill für .308 und 7X57R vorhanden
Kann verändert werden je nach Länge und Durchmesser der Patronen.
STL / 3Mf / STEP-Dateien enthalten. (erstellt mit Solid Edge)
Wenn ihr das Kaliber gravieren wollt einfach im Slicer einen Text erstellen ihn als Modifier umändern und die “Embeded depth” auf 2 stellen.
-0,2mm Schichthöhe
-20%Infill
Erforderliche Schrauben und Muttern:
- 8x M3x20
- 8x M3 Mutter
Montage:
- Das Infill muss evtl. mit einem Gummihammer bis ganz unten eingepresst werden sonst schließt der Deckel nicht ganz ab.
!0,5mm Luft zum Boxboden ist mitgerechnet!
Falls es zu locker reingeht würde ich ein paar Tropfen Sekundenkleber verwenden.
- Die M3-Muttern habe ich per zugtechnik in die versenkungen eingeschraubt.
(einfach das jeweilige Verschlussteil ansetzen die M3-Schraube einschrauben bis es nicht mehr weiter geht dann die Mutter ansetzen und die Mutter einziehen lassen)
Update:
Einfachen Verschluss hinzugefügt
M3 Schraube am Boden einschrauben da diese als Riegel dient.
Würde mich um Feedback freuen :D
LG
-------------------------------------------------
Ammunition boxes to customize
Infill available for .308 and 7X57R
Can be changed depending on the length and diameter of the cartridges.
STL/3Mf/STEP files included. (created with Solid Edge)
If you want to engrave the caliber, simply create a text in the slicer, change it as a modifier and set the "Embeded depth" to 2.
-0.2mm layer height
-20%Infill
Required nuts and bolts:
- 8x M3x20
- 8x M3 nut
Assembly:
- The infill may have to be pressed in with a rubber mallet to the very bottom, otherwise the lid will not close completely.
!0.5mm of air to the bottom of the box is included!
If it goes in too loosely, I would use a few drops of superglue.
- I screwed the M3 nuts into the recesses using the pull technique.
(simply attach the respective locking part, screw in the M3 screw until it doesn't go any further, then put the nut on and let the nut retract)
Update:
Added easy closure
Screw in the M3 screw on the floor as this serves as a latch.
Would appreciate any feedback :D