This Emoji lightbox can be easily assembled without any glue or tools!

It is designed to snap together into place and provides even mounting brackets for the LED strip and cable.

This is the LED strip I used but I'm sure other similar LED strips will fit too (you will need about 0.65m of LEDs):

https://amzn.eu/d/06IKclh

Now let's assemble it!

First put the LED strip through the hole from the back to the inside.

Push it all the way through until the beginning of the cable sheath lies next to the cable bracket as shown. It can be a little tight, so please be gentle. Now put the LED strip into the brackets as shown here.

Cut off the overhang at one of the cutting marks on the LED strip.

Tighten the cable to the bracket to prevent it from being pulled out.

Now it should look like this. This is the right time to check the lights before putting it together.

After this, It's time to put it all together!

It's easier to fit one of the edges first and make my way to the other side but without pushing the two parts together completely.

Before pushing it all the way together, make sure that everything fits nicely!

Now push it together and you should hear the brackets snapping into place.

You're done!

Have fun and don't forget to leave some pictures or a comment.