Ergonomic bike grips
Copyright Claim
Ergonomic bike grips
Boost
50
84
12
Print Profile(2)
0.16mm layer, 2 walls, 10% infill
Designer
5.5 h
1 plate
A1 mini - 0.16mm layer, 3 walls, 10% infill
Designer
8.2 h
1 plate
Boost
50
84
12
0
114
49
Released
Description
Really nice ergonomic bike grips, one piece design. Print in TPU (matte if you can find). You can vary the infill if you want softer or harder handles.
Inner diameter fit most bikes handle bars (~22 mm).
Comment & Rating (12)
All
Print Profile
A1 mini - 0.16mm layer, 3 walls, 10% infill
My word, this profile is the Michelangelo of 3D printing! It's a masterpiece sculpted from pure printing perfection!
The designer has replied
1
Reply
🩶
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
lots of stringing, and the print was warped on the parts that would normally have support. Overall the handles are probably usable but definitely not ideal
The designer has replied
0
Reply
No supports necessary. Stringing is dependent on the filament used and not on the model, what filament did you use? You might need to reduce the speed if you get stringing.
(Edited)0
Reply
I've used this filament on a handful of different projects before with no problems, it should be able to handle it with my default settings
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
came out great with TPU 95A HF in Grey
The designer has replied
1
Reply
great to hear!
0
Reply
Printed great, but on my 22mm handle bar the soft TPU is not tight enough although I needed a hammer to get them on the handle.
The designer has replied
0
Reply
You could maybe use some gripper paste to make it more secure
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld