Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
Boost
33
66
13
0
200
95
Released
Description
Charger Cable Organizer with a nice Design.
have fun with it
Comment & Rating (13)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
(Edited)
Strength Issue:the 3 Part Design sadly doesnt hold well together when you Twist the Box to roll up the cable.
Other Issues:Looks great, but the design is flawed. the tiny holes dont allow for the Heads of cables to fit through them, rendering the object unusable. ive cut the holes in order to use it.
0
Reply
They look good, but either im too dumb to get in the cable or it isnt possible with this design. how do you want to fit the heads of the cable through the hole?
0
Reply
You have to insert the cable before you assemble the organizer.
Lay your cable so the middle of it is through the slot in the pin and the two ends hang out of the holes on either side. Then snap it together.
The organizer stays on the cable when you unroll it and use it.
(Edited)0
Reply
Replying to @WebGuy3D
you would have to lay in the cable whilst printing. there is no way to fit the cable when printed, even unassembled. sorry if im being a massive dumbass here but i can not see a way to lay in the cable whilst unassembled, since the holes arent open.
0
Reply
Replying to @PinkPanther
I actually answered your question before my print was done.
The way I got my cord in is by sticking the USB C end into the hole on the side of the organizer, placing the center pin barely inside the organizer, then pushing the USB C end through the opposite hole in the organizer.
If your device end (USB C, USB Mini, Lightning, etc) won't fit through the hole you'll probably get better results if you reprint it slightly larger. Increase all 3 pieced by the same percentage in the resizer.
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Some cables and cable ends Donny fit through the slots. Mostly the extra cheap kinds of cords the bulky plastic mouldings.
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
charger would not fit through sides had to cut but works good
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Easy print works nicely.
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Works great for travel. Great design. Thank you.
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
hat alles super funktioniert
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld