The piece in the middle of this photo looks to be split into two pieces. However, that piece in the print profiles seems to be one solid piece. Can you help me understand this?
Realy great model, I like it. I had to do a little bit of sanding on a few parts but not a big deal.
Lampkit from EU, ordered in February or a few weeks before.
After finally getting around to assembly, the light switch is not far enough down in the light kit wire to go to the base, it goes halfway to the second arm of the lamp so this model is outdated now
yes so the length of the cord was probable the same, but the switch is now about in the middle of the wire now where it seems in your model, the switch was more towards the usb part of the wire
Is there a way to print this in A1 Mini? Tried printing in A1 mini but seems like some pieces are out of the plate :( Don't know how to fix that and not mess up other measurement.
The arms are to long for the mini. it works need to be modified in Autocad. I may try and do that for you. if I can get it to work I will ket you know.
@SirBranson I modified the arms to be 8 mm shorter to fit the A1 mini bed. Use the new profile I made labeled "A1 mini." You will need to print two of each of the arm halves.
Standard orientation how you have it is with the little holes up towards the nozzle, but I flipped it so those are on the plate. In your pictures you can see you had the holes of it on the base plate because you can see the textured plate design
I really Liked the Light. Good print, had to turn the bell over on the plate to print without supports. Also sucks that Bambu changed the design of the 001 light kit so that the switch no longer reaches the base.